Sika® Separol Plus
Mould Release Agent
Ready to use low viscous mineral oil based mould release agent. Ready to use and easy to apply.
Sika® Separol Plus when used, provides following beneficial properties:
- Forms stable thin film when dried up
- No dirt sticks on surface after it is dried
- Clean, fast and easy stripping of formwork
Usage
Sika® Separol Plus can be used on moulds to obtain clean and smooth concrete surface and it’s use facilitates fast and easy removal and cleaning of:
- Steel formwork
- Plastic formwork
- Timber formwork
- Aluminium formwork
- Heated formwork
Packaging
230 litres Drums
Advantages
Sika® Separol Plus when used, provides following beneficial properties:
- Forms stable thin film when dried up
- No dirt sticks on surface after it is dried
- Clean, fast and easy stripping of formwork
- Extended life of formwork
- Improved finish stain and air-hole free fair-faced concrete
- Reduced concrete contamination
- High coverage
- Does not corrode steel
- Environment friendly product
Colour
Brownish oily liquid
Product Details
Application
Consumption
Steel, Aluminium or Plastic formwork 40-60 m2/l and Timber form 30 m2/l. The consumption is dependant on the surface texture and porosity of the formwork. Actual dosage to be finalised on the basis of site trials.
APPLICATION
The moulds should be dry and clean.
Any residues of rust and concrete must be removed.
Sika® Separol Plus is applied in thin layers, covering the complete surface
(a second application may be necessary in case of highly absorbent formwork).
We recommend the use of a special spray gun with an operating pressure of
3-6 bar and a flat spraying nozzle.
Application by a brush, roller or cloth is also possible.
Accumulations of Sika® Separol Plus should be avoided.
Any excess should be wiped off using a cloth or sponge.
Before concreting preliminary test are recommended to optimise the procedure for each project.